« previous next »
Pages: [1]   Go Down

Author Topic: Barrel breech quesiton...  (Read 538 times)

0 Members and 1 Guest are viewing this topic.

Offline rdlange

  • GBO Supporter
  • Trade Count: (52)
  • Senior Member
  • *****
  • Posts: 1122
  • Gender: Male
Barrel breech quesiton...
« on: June 09, 2012, 06:06:42 AM »
Got this Huntsman.  The barrel is tight to the breech all around.  Do I need to... how do I cut out the top of the barrel to make it 'open' please?  I'll be mounting a scope.  Didn't see this in the FAQs.  I'll keep looking though...

Thanks
Logged
Think as if you LIFE depends on it... IT does..!  Be Well...

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Barrel breech quesiton...
« Reply #1 on: June 09, 2012, 08:00:19 AM »
I just used the mill to cut the top of the barrel open forward to the breech plug, the same could be done with a dremel, mine is a modern barrel with the opening for the primer carrier, so I didn't feel the need to open it up any more, you could make an opening on each side also, but the factory made barrels I've seen(older H&R M156W, Traditions NW edition) just have one opening at the top of the barrel.

Tim

http://www.gboreloaded.com/forums/index.php/topic,238470.msg1099355161.html#msg1099355161
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »