« previous next »
Pages: [1]   Go Down

Author Topic: ball seating depth in an 1858  (Read 982 times)

0 Members and 1 Guest are viewing this topic.

Offline Matt85

  • Trade Count: (0)
  • Member
  • *
  • Posts: 28
ball seating depth in an 1858
« on: June 14, 2012, 10:10:36 AM »
up untell yesterday when seating balls in my pietta 1858 i would just pull the ramming rod down as far as it would go. however last night i noticed i was starting to chew into the little arm between the rammer and the rod where it hits the frame. now some damage here is unavoidable since its two different hardness of metal hiting each other but i worry that constant hitting the arm against the frame with the force of pushing the ball in might chew a little deap.
 
do you guys seat yer balls all the way in or do you stop before reaching the guns limit? (for the 1858 new army)
Logged

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: ball seating depth in an 1858
« Reply #1 on: June 14, 2012, 03:47:15 PM »
In my ROA with std. loads, it doesn't bottom out.  Don't have a Pietta though for comparison.  What charge are you using?
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Offline m-g Willy

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1739
Re: ball seating depth in an 1858
« Reply #2 on: June 14, 2012, 04:00:48 PM »
Quote from: Matt85 on June 14, 2012, 10:10:36 AM
up untell yesterday when seating balls in my pietta 1858 i would just pull the ramming rod down as far as it would go. however last night i noticed i was starting to chew into the little arm between the rammer and the rod where it hits the frame. now some damage here is unavoidable since its two different hardness of metal hiting each other but i worry that constant hitting the arm against the frame with the force of pushing the ball in might chew a little deap.
 
do you guys seat yer balls all the way in or do you stop before reaching the guns limit? (for the 1858 new army)
Are you using powder under that ball?
Just kidding ya!
Theys 44s not 22s.
Load that cylinder like you're going to be shooting from the back of a charging horse!
Logged

Offline Matt85

  • Trade Count: (0)
  • Member
  • *
  • Posts: 28
Re: ball seating depth in an 1858
« Reply #3 on: June 14, 2012, 07:51:45 PM »
i shoot with 30-35 grains (by volume) of pyrodex with a wonder wad and a .454 ball. from what i understand 30 grains is a pretty normal load for these pistols.
Logged
Pages: [1]   Go Up
« previous next »