« previous next »
Pages: [1]   Go Down

Author Topic: Contender Hardware Question  (Read 642 times)

0 Members and 2 Guests are viewing this topic.

Offline vanbuzen9

  • Trade Count: (16)
  • Avid Poster
  • **
  • Posts: 197
  • Gender: Male
Contender Hardware Question
« on: June 17, 2012, 02:40:51 AM »
Guys,
I recently purchased a non-G2 contender with the black plastic grips. I bought a walnut grip (with the rubber pad) for it online, and it appears that the grip screw I'm currently using on the plastic grip is too short. Do I need a longer grip screw to use the wooden grips?
I also purchased an octagon forearm, and when I tighten the screw all the way down for this, it still teeters back and forth. Do these octagon forearms need a different length screw? Possibly an additional washer?
Any help in this matter would be appreciated!
Logged

Offline DEACONLLB

  • GBO Supporter
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 2458
  • Gender: Male
Re: Contender Hardware Question
« Reply #1 on: June 17, 2012, 03:01:02 AM »
Yes to both questions, butt grip screw is 1/4-20 just measure the length and make sure it is not too long or frame will not cock You can add a washer to the forend screw if it is not way too long or just cut or grind some off to shorten it.
the forend screw is 8/32 and you can get all this at a good hardwear store or gun shop.
Deaconllb
Logged
Korean war vet. NRA Member
Fourth fighter wing K14 Kimpo Korea 1952 Fourth but first, the mig killers.
533rd material ,air defense Oxnard AFB 1953-1955
Pastor of the  CBCG-Fellowship group Tulsa Oklahoma.

Offline Ladobe

  • Trade Count: (91)
  • Senior Member
  • *****
  • Posts: 3193
Re: Contender Hardware Question
« Reply #2 on: June 17, 2012, 03:17:54 AM »
First thing I'd so is make sure the forend stand-off is tight in the barrel - you can get wobble if not.   Easy enough to stake it to tighten it if loose.   That done here's three easy choices - shorten the existing screw you have, buy a shorter one or shim the forend.   Last option on a single screw mounted forend would be my last pick though unless it was shimmed near full length of the barrel channel.
 
 
Logged
Evolution at work. Over two million years ago the genus Homo had small cranial capacity and thick skin to protect them from their environment. One species has evolved into obese cranial fatheads with thin skin in comparison that whines about anything and everything as their shield against their environment. Meus

Offline vanbuzen9

  • Trade Count: (16)
  • Avid Poster
  • **
  • Posts: 197
  • Gender: Male
Re: Contender Hardware Question
« Reply #3 on: June 17, 2012, 03:50:45 AM »
Thanks for the info guys!
Logged
Pages: [1]   Go Up
« previous next »