« previous next »
Pages: [1]   Go Down

Author Topic: best way to do a crown ??  (Read 660 times)

0 Members and 1 Guest are viewing this topic.

Offline fox fire

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 207
best way to do a crown ??
« on: September 07, 2012, 03:19:13 PM »
I tossed the idea of cutting down a barrel on my .243, all week been dig'n around for some food for thought on how to recrown it, will a hand tool produce the same results as turning it in a lathe ??
Logged
I've never been lost,,,just rite fearsome confused for a few months.

Offline mechanic

  • GBO Supporter
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 5112
  • Gender: Male
Re: best way to do a crown ??
« Reply #1 on: September 07, 2012, 03:32:04 PM »
If you go  to the H&R centerfire forum, and look in the FAQ's there is a video available on crowning.
 
Ben
Logged
Molon Labe, (King Leonidas of the Spartan Army)

Offline fox fire

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 207
Re: best way to do a crown ??
« Reply #2 on: September 11, 2012, 03:39:05 PM »
I've watched plenty of videos & understand how its done, what I want to know is weather turning the barrel on a lathe produce a better functioning crown than one done by hand ?
Logged
I've never been lost,,,just rite fearsome confused for a few months.

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: best way to do a crown ??
« Reply #3 on: September 11, 2012, 05:19:37 PM »
I really would like to say yes but I've no real knowledge.. I usually just use the handtools rather than set it up in the lathe.. May just be lazy..but thet produce excellant results..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »