« previous next »
Pages: [1]   Go Down

Author Topic: Model 94  (Read 808 times)

0 Members and 1 Guest are viewing this topic.

Offline GH1

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 939
  • Gender: Male
Model 94
« on: September 25, 2012, 07:20:46 AM »
I just purchased one and the trigger pull is Hellacious, has anyone got any ideas on how to lighten it? I talked to the folks at Wolf Spri ng and they don't offer a kit, due to misfiring.
GH1 :)
Logged
I owe my life to an organ donor

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26944
  • Gender: Male
Re: Model 94
« Reply #1 on: September 25, 2012, 11:31:46 AM »
Swap it for a S&W. That's what I did with both of the M94s I've owned.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline NickSS

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 384
Re: Model 94
« Reply #2 on: October 27, 2012, 11:20:38 PM »
I had the same problem so I took the springs out (mainspring and trigger spring) and cut a coil off of each and reassembled it.  The result was an improvement so I cut another coil off of each spring and the results were a much improved trigger pull and it still reliably fires in both single and DA.  If you do this go slow and do not take too much off.  I did that on one Taurus and rather than buy a new spring I added a small washer to the bottom of the spring and now it works properly.
Logged
Pages: [1]   Go Up
« previous next »