« previous next »
Pages: [1]   Go Down

Author Topic: 22-6mm  (Read 597 times)

0 Members and 1 Guest are viewing this topic.

Offline jde650

  • Trade Count: (0)
  • Member
  • *
  • Posts: 23
22-6mm
« on: January 24, 2013, 10:00:03 AM »
Would 0.035 difference between chamber length and case length cause blown primers in a encore barrel.
Logged

Offline prairie fire

  • Trade Count: (2)
  • Member
  • *
  • Posts: 19
Re: 22-6mm
« Reply #1 on: January 26, 2013, 09:16:50 AM »
35 thousandths  ( .035 as you typed it ) is a whole lot in headspace world. But .0035" (three and a half thousandths) is not too bad.
Logged

Offline Catfish

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2696
Re: 22-6mm
« Reply #2 on: February 17, 2013, 02:39:21 PM »
No. I have used brass in some wildcats that had necks that were that short and did not blow primers. If your blowing primers you eather have high presure or louse primer pockets. If your running high presure your brass should be sticking in the chamber and hard to eject.
Logged
Pages: [1]   Go Up
« previous next »