Author Topic: heavy loads in 45 Colt Redhawk  (Read 518 times)

0 Members and 1 Guest are viewing this topic.

Offline hansg/Ups

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 147
heavy loads in 45 Colt Redhawk
« on: February 15, 2013, 08:53:05 AM »
Has anyone done heavy cast loads in a Redhawk 45Colt,specifically:325,340,380 gr.
Results,load data?
SN I'll be using Starline brass..
Thanks.

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: heavy loads in 45 Colt Redhawk
« Reply #1 on: February 15, 2013, 02:35:10 PM »
I've done some .45 Colt with 300 gr. XTP Magnums and book loads of H110.  Good performer, but bit hard on the wrist after a few shots.  I use em only in bear country.  ;)
Might check out this link (has a few bigger bullets):
http://www.customsixguns.com/writings/dissolving_the_myth.htm
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.


Offline 41 mag

  • Trade Count: (1)
  • Contributor
  • ***
  • Posts: 254
    • My Pictures
Re: heavy loads in 45 Colt Redhawk
« Reply #2 on: February 19, 2013, 11:44:54 PM »
I have only gone as far up as the Lee 300gr. From what results I got I decided that the 250-270gr bullets were simply all I needed for it.

The link above explains it all very well, and I am now using the 260gr load mentioned at the very bottom of the write up The Myth. It uses like 13grs of HS-6 with the 260, and that load will simply tear out a ragged hole in the bull out to 75yds form my RH. I doubt seriously anything I put one to task on, is going anywhere fast but straight down.