« previous next »
Pages: [1]   Go Down

Author Topic: OAL problem with Lee Factory Crimp Die  (Read 464 times)

0 Members and 1 Guest are viewing this topic.

Offline Singlebarrel

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 157
  • Gender: Male
OAL problem with Lee Factory Crimp Die
« on: February 15, 2013, 01:14:18 PM »
Anyone having a problem with the Lee Factory Crimp Die messing up the OAL?  When I seat cast bullets in my pistol rounds, when I use the crimp die it shortens everything up.  I am having a hard time getting the crimp where I want it and the OAL where I want.
Logged

Offline Savage

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4397
Re: OAL problem with Lee Factory Crimp Die
« Reply #1 on: February 15, 2013, 01:50:50 PM »
No such problem here.
Savage
Logged
An appeaser is one who feeds the crocodile hoping it will eat him last,

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: OAL problem with Lee Factory Crimp Die
« Reply #2 on: February 15, 2013, 02:38:06 PM »
What caliber?  I've never seen any issue using these on about 10 different calibers I have them for.  Are you sure you don't have like a .38 special crimp die mixed in with .357 or something similar?
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Offline Singlebarrel

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 157
  • Gender: Male
Re: OAL problem with Lee Factory Crimp Die
« Reply #3 on: February 16, 2013, 06:00:11 AM »
Thanks for the replys. No, I do have the appropriate brass for the caliber and I have this problem with the 357, 44 Mag and 45 Colt. 
The dies for my pistols are different from my rifle crimp dies.  The rifle dies have an open top and a slotted crimp tub.  The pistol dies adjust with a shaft with threads.  I have no problems with the rifle dies, even with the cast loads for the 45-70.  Only with cast loads in the revolvers is the problem showing up.   Maybe I am screwing the shaft down too far, although I am doing right now exactly what the directions say do. 
What is happening is that I set the seating die for an OAL of say, 1.600.  After the crimp the OAL is 1.580 or thereabouts. This is driving me nuts.
Logged
Pages: [1]   Go Up
« previous next »