« previous next »
Pages: [1]   Go Down

Author Topic: need a top punch for lbt mold  (Read 807 times)

0 Members and 1 Guest are viewing this topic.

Offline Jason F

  • Trade Count: (261)
  • Senior Member
  • *****
  • Posts: 2105
  • Gender: Male
need a top punch for lbt mold
« on: February 19, 2013, 01:11:49 PM »
Just acquired a 225-60 sp lbt mold.  Can you tell me how to go about ordering a top punch for this mold. Thanks jason
Logged
handi rifles- 22 mag      22 hornet    223      7mm-08      308 chip shot     30-30 x2     30-06 shorty      358 cheez whiz     357 max     35 remington     375-08    410 rifled slug     454 casull     460 s&w     45 smokeless muzzleloader x2     45-70    50 huntsman    50-70 government shikari     20 ga.ush     12 ga.ush    12 ga.3 1/2     10 ga.imp.cyl. slug gun

Offline calvon

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 274
  • Gender: Male
Re: need a top punch for lbt mold
« Reply #1 on: March 05, 2013, 10:14:36 AM »
I'd suggest you send the mold back to the man who made it and ask him to make your top punch.


http://www.lbtmoulds.com/




Logged

Offline Veral

  • GBO Sponsor
  • Moderator
  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1675
    • Lead Bullet Technology
Re: need a top punch for lbt mold
« Reply #2 on: March 09, 2013, 06:13:31 PM »
  I suggest that you send only a bullet from the mold and I'll make you a fitted punch for $10.  I can also make punches for about any bullet from other mold makers,  if you have a problem finding one.  Contact me on that before ordering.  Shiping for one or several punches is $ 5.  So send as many different bullets as you want punches for.
 
  I can now rebore Saeco punchs to LBT nose forms. and will make punchs for strange molds as well.. (Old obsolete, other moldmakers etc.)  but contact me by email about these two options.
Logged
Veral Smith
Pages: [1]   Go Up
« previous next »