« previous next »
Pages: [1]   Go Down

Author Topic: Transfer Bar Problem  (Read 409 times)

0 Members and 1 Guest are viewing this topic.

Offline Roudy

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 206
Transfer Bar Problem
« on: March 16, 2013, 02:50:40 AM »
I'm having a problem when cocking the hammer on my model 157.  The transfer bar hangs up on the rear of the firing pin.  If I point the muzzle in the air gravity will cause the transfer bar to fall back and miss the firing pin letting the hammer be cocked.  Do I have a weak spring?
Logged

Offline rangerwillie

  • GBO Supporter
  • Trade Count: (29)
  • Avid Poster
  • *****
  • Posts: 178
Re: Transfer Bar Problem
« Reply #1 on: March 16, 2013, 04:11:23 AM »
I HAD THE SAME PROBLEM ON MY 45-70 LAST FALL, THE HINGE PIN ON THE TRANSFER BAR WAS BENT. TIME FOR A TEAR DOWN.  DAN
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Transfer Bar Problem
« Reply #2 on: March 16, 2013, 05:15:04 AM »
T-bar needs repair/replacement, Numrich had em last I looked, use the trigger work info in the FAQs, Perklo's has detailed info on the t-bar.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline gcrank1

  • Trade Count: (24)
  • Senior Member
  • *****
  • Posts: 7644
  • Gender: Male
Re: Transfer Bar Problem
« Reply #3 on: March 17, 2013, 04:08:04 AM »
There is a chamfer on the firing pin side that is supposed to aid it to lift past without snagging the pin; you might have a little 'lip' or burr there?
Logged
"Halt while I adjust my accoutrements!"
      ><   ->
We are only temporary caretakers of the past heading toward an uncertain future
22Mag UV / 22LR  Sportster
357Mag Schuetzen Special
45-70  SS Ultra Hunter with UV cin.lam. wood
12ga. 'Ol' Ugly OverKill', Buck barrel c/w  SpeedStock  and swap 28" x Full bird barrel, 1974
Pages: [1]   Go Up
« previous next »