« previous next »
Pages: [1]   Go Down

Author Topic: Octagon Barrel Question  (Read 514 times)

0 Members and 1 Guest are viewing this topic.

Offline Clambo

  • Trade Count: (0)
  • Member
  • *
  • Posts: 17
Octagon Barrel Question
« on: February 17, 2014, 06:22:32 AM »
Evening Handi Gents,

Im back again with what will probably amount to another newbie question. Was there ever a factory octagon .30-30 barrel offered?  If not what is the procedure to make one?  Could a guy buy a heavy barrel and mill it?  Maybe Im into stub territory but I hope not. I just want to do something a little different with my now decided upon .30-40 project.

Thank You

Clambo
Logged

Offline gcrank1

  • Trade Count: (24)
  • Senior Member
  • *****
  • Posts: 7644
  • Gender: Male
Re: Octagon Barrel Question
« Reply #1 on: February 17, 2014, 06:33:30 AM »
No factory oct., and you can mill it; std. procedure in a set of v-blocks jacked for the taper.
Logged
"Halt while I adjust my accoutrements!"
      ><   ->
We are only temporary caretakers of the past heading toward an uncertain future
22Mag UV / 22LR  Sportster
357Mag Schuetzen Special
45-70  SS Ultra Hunter with UV cin.lam. wood
12ga. 'Ol' Ugly OverKill', Buck barrel c/w  SpeedStock  and swap 28" x Full bird barrel, 1974

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Octagon Barrel Question
« Reply #2 on: February 17, 2014, 08:12:17 AM »
See the octagon barrel link in the FAQs sticky, I've done two, a straight taper 444 barrel and tapered 405 Win barrel.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »