Having a Saeco lube-sizer for about 30 years, made a little change. Was a pain in the butt to push down, and then lift back up. Didn't mind it for gas checked bullets, but gave it a little thought for my bullets that don't take them. So, took the punch that push's them back up off. Then, removed the center pin that kept the lube from squeezing out in the middle of the sizing die. Backed off the plunger that puts pressure on the lube naturally. Fitted a tube to a Tupperware container that sits on a stand just under the sizer. Put an old towel in the bottom of the container. So now, just push the bullets threw the sizing die, they roll down the tube into the Tupperware container. When I get a batch down, warm up some Lee liquid alox, put them into a small plastic tube, roll them around, let them dry. Using this method for my .40 cal and .45 acp bullets. Wish I'd had thought of this years ago. Much faster!
