Author Topic: Groups with factory ammo  (Read 377 times)

0 Members and 1 Guest are viewing this topic.

Offline longwinters

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3070
Groups with factory ammo
« on: April 17, 2004, 01:40:38 PM »
What kind of groups do you get using factory ammo out of your Encore rifles?  Just wondering because factory ammo seems to  be more than the .010 - .030 OAL from the lands of most Encore rifles, like most people say is a good measurement for accuracy.

long
Life is short......eternity is long.

Offline New Hampshire

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 996
Groups with factory ammo
« Reply #1 on: April 17, 2004, 03:59:17 PM »
I managed a little under 2" groups using Fedral classic loads in my 06.  They were 125 grain Soft points.  Yes most guns will find a "happy zone" around the .010 to .030 " mark, but guns a funny.  They have personality all their own.  So Im POSITIVE someone is gonna write here they are getting 1/2 MOA from their favorite factory loading.  But more than just that accuraccy comes from consistancy.  Its more about making every round as close to the same as possible.  So you can still get amazing accuracy as long as any, some or all of the following things remain consistant: case length, powder charge weight, bullet seating depth, primer burn consistancy.  Amazing thing aint it?  How something inanimate takes on a life of its own.

 :D
Brian M.
NRA Life Member
Member Londonderry Fish and Game Club
Member North American Fishing Club
Member North American Hunting Club
Member New Hampshire Historical Society
Member International Blackpowder Hunting Association

Offline Runs with Scissors

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 173
Groups with factory ammo
« Reply #2 on: April 18, 2004, 03:29:10 AM »
I've been shooting Sellier and Belliot ammo.
I'm getting 2" groups with their 130 grain, .270 FMJ cartridges.
That's OK with factory stuff.
Now, with their 55 grain, 223 FMJ, I'm getting 1/2" groups.
That's great with factory stuff :grin:

Bill
Measure twice. Cut once.

Offline DaddyPaul

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 180
Groups with factory ammo
« Reply #3 on: April 19, 2004, 08:39:33 AM »
My .270 standard taper barrel spits 'em out in the 1.5" range pretty much across the board.  Win BST, Hornady SST and Rem PSPCL.  Does a little better with handloads.  Would probably do better in the hands of a shooter!

Offline Bullseye

  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 1879
Groups with factory ammo
« Reply #4 on: April 19, 2004, 03:08:41 PM »
Heck I reload all my calibers to the industy OAL.  Accuracy is always good and I have not seen any earth startling accuracy improvements when I have seated them out closer to the rifling.  But now, I know that goes against everything we have been tought about reloading!