Author Topic: .17 Akley Hornet  (Read 501 times)

0 Members and 1 Guest are viewing this topic.

Offline UMFAN1

  • Trade Count: (0)
  • Member
  • *
  • Posts: 93
.17 Akley Hornet
« on: June 15, 2004, 06:13:10 AM »
I've recently started to read alot about this cartridge, and am wondering what if anything special is involved with reloading this cartridge?
.35 CALIBER MAN

Offline ricciardelli

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1004
  • Gender: Male
    • http://stevespages.com/page8.htm
.17 Akley Hornet
« Reply #1 on: June 15, 2004, 07:09:41 AM »
Well, think about this...

.22 Hornet brass is a bitch to load.
.17 caliber bullets are a bitch to load.

What happens when you combine them both?

Offline mulerider

  • Trade Count: (0)
  • Member
  • *
  • Posts: 18
.17 Akley Hornet
« Reply #2 on: June 15, 2004, 09:25:05 AM »
For some intelligent discussion on the 17 Ackley Hornet, try saubier.com forum. Bunch of great shooters of the sub-.224 persuasion.
I have a 17 Mach IV, great little cartridge, but the 17 Ack Hornet is probably the perfect blend of powder capacity and caliber, at least for 20-25 gr bullets.

Offline Catfish

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2696
No problems
« Reply #3 on: June 20, 2004, 01:48:40 PM »
The .17 AH is my carry gun through the summer. I shoot the 19 grn. Calhoon bullet and push it to 3,600 fps. I`ve seen post were some guy are claiming 3,900 with Lit`le gun, but the only powder I`ve tried is H-4227. When I got to max. loads with it I was getting groups of about 1/4 min. and have been so happy with my first load that I`ve never tried anything else. One thing bad about it though is that presure jumps very fast in this small case. When working up you load do it on a hot day and increase you powder charges by 1/10 of a grain of powder at a time. Case forming is easy. Just run .22 Hornet cases through your seating die and then through your sizeing die, no form dies required. If you get one I would recomand getting a tight neck chamber and this will require neck turning. If your not already a wildcatter this is really not a good round to start with unless you can get live advice from someone with experance in wildcating. The load I shoot is point blank, no more than 2 1/2 in. high or low, to just over 290 yrds. and that`s with 10.4 grns. of powder. It will drill a .30 cal. hole in a piece of 1/4 in. steel. If you have any more questions you can PM me.

Offline bgjohn

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 602
.17 Akley Hornet
« Reply #4 on: June 20, 2004, 01:53:49 PM »
Quote from: ricciardelli
Well, think about this...

.22 Hornet brass is a bitch to load.
.17 caliber bullets are a bitch to load.

What happens when you combine them both?


Hornet brass is easy to load if you use Lee Collet dies.
JM
I know nothing. I am only a messenger.