« previous next »
Pages: [1]   Go Down

Author Topic: A Site Problem  (Read 348 times)

0 Members and 1 Guest are viewing this topic.

Offline WV1%er

  • Trade Count: (0)
  • Member
  • *
  • Posts: 15
A Site Problem
« on: June 18, 2004, 05:54:48 AM »
Hi all! I'm in the process af changing all of my Contender barrels to scope mts. Problem: the back sites on two of my barrels don't want to come off. The others were simple enough. Remove top adjustment screw. The top flips over and remove the 4 mt. screws. These however catch on the back, and won't flip up. I tryed to remove the side adjustment screw, and the v slides over but stops, short of comming out. It feels like any more torque would break something. Are some rear sights unremoveable, or am I doing it wrong? Thanks in advance for any suggestions or comments.
 WV1%er
Logged

Offline Hopalong7

  • Trade Count: (20)
  • Senior Member
  • *****
  • Posts: 1673
  • Gender: Male
A Site Problem
« Reply #1 on: June 18, 2004, 06:19:05 AM »
These sound like the older sights.  If the're like mine, drift out the front pin(where it pivots) then remove the adjustment screw and the sight should slide forward and out.  GOOD SHOOTIN', Walt  :grin:
Logged

Offline B_Koes

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 207
A Site Problem
« Reply #2 on: June 18, 2004, 06:19:42 AM »
I suspect that you need to remove the roll pin that holds the elevation adjustment arm to the rear sight base.  It takes a 1/16" punch or similar sized tool.

The later sights are of a different design and allow you to just unscrew the elevation adjustment screw and the arm will swing up and allow access to the screws holding the base to the barrel.
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
A Site Problem
« Reply #3 on: June 18, 2004, 06:19:56 AM »
Use a small pin punch and remove the pin where the sight pivots.  Then you can get to the screws. :grin:


SORRY I DID NOT SEE THE REPLYS FROM OTHERS OR WE DID THEM AT THE SAME TIME ACCORDING TO THE POST TIMES  :oops:
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline WV1%er

  • Trade Count: (0)
  • Member
  • *
  • Posts: 15
A Site Problem
« Reply #4 on: June 18, 2004, 06:55:27 AM »
Wow! That was fast. Thanks a lot! I asked for your help less than an hr. ago & now my sites are both off. I really appreciate your expert suggestions. Mission accomplished! Thanks again.
  WV1%er
Logged

Offline skb2706

  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 1428
A Site Problem
« Reply #5 on: June 18, 2004, 09:26:25 AM »
three guys answered the same question the same way at the same time..............bet ya couldn't do that again if you tried.
Logged
Pages: [1]   Go Up
« previous next »