Author Topic: LeftoverDJ can make some fine bullets (Read 529 times)

mag41vance · « **on:** July 29, 2004, 02:18:53 PM »

This is a load I worked up from DJ's cast .311 diameter bullets.

That three shot group is under .317 inches at 100yds.

Thanks for the samples DJ!
RV

Deadeye47 · « **Reply #1 on:** July 29, 2004, 03:48:09 PM »

That is a dead deer load! I'd have to say I agree with ya! Nice shootin!

Wlscott · « **Reply #2 on:** July 30, 2004, 04:24:47 AM »

If I can find my camera, I'll try to post a pic of the last group I shot with bullets cast from DJ's 459-405HB mould.

It stacked three in the same hole, then the last two were stacked a half inch away :eek:

This is with a 45-70.

I'll be ordering a mould to match his shortly.

Longcruise · « **Reply #3 on:** July 30, 2004, 06:45:41 AM »

Looks like a great shooting mold and a dandy all around bullet.

Is this a GC type? Where does one obtain the mold?

Thanks for posting.

Wlscott · « **Reply #4 on:** July 30, 2004, 07:18:16 AM »

Cruise, The bullet I tried out is not a gas check bullet. But it looks like the one that Deadeye tried is a gas check.