Author Topic: Savage 99 stock (Read 498 times)

tscott · « **on:** September 08, 2004, 09:53:06 AM »

I have a Savage 99f, in super shape. Sure it has wear that adds to its character, where it has been held while hunting. The stock is walnut,
and has nice figure for a production gun. There are no dents, etc.
The finish / original varnish was non existant. About a year ago, I put on a coating of Beechwood Casey stock finish... It's way to glossy for me
and not original looking... This is my go to deer rifle, with only 35 shots through it... I want to make it look like it did in 1955. At least stock wise.
I have taken off all finish with nail polish remover...Wood is terrific!!!
Where do I go from here?

C A Plater · « **Reply #1 on:** September 08, 2004, 04:08:37 PM »

I would go with Linspeed or Tru-oil for the finish. It would match the original and bring out the grain of the wood. I have a similar vintage one with the original finish still on and it is definitely an oil type finish. Good luck with your project.

Prince of Wales · « **Reply #2 on:** September 10, 2004, 08:19:00 AM »

I agree with CA Plater. Use Linspeed or TruOil and steel wool it til the high gloss is gone and pores are filled to a smooth satin. From there an occasional application of boiled linseed oil and hand rubbing will give the prettiest finish I know of. POW

jon f · « **Reply #3 on:** September 18, 2004, 03:48:29 PM »

I agree with POW. You won't get a better , more original looking finish.