Author Topic: BPS roll pin fell out (Read 408 times)

james · « **on:** October 11, 2004, 12:27:51 PM »

I was cleaning a new purchase and I took out the trigger mech to clean it. There was a lot of grease, grass seeds etc. and I dumped the gunk out of the receiver and a roll pin came out too. - About 3/4 in long and 3/16 in dia. can anyone point me to an exploded view. I'm familiar with rem 1100s but not the BPS. In the mean time I'll keep tinkering.- I suspect the top,(small) receiver pin goes thru it.
thanks
James

Iowegan · « **Reply #1 on:** October 11, 2004, 12:34:43 PM »

Here's a schematic that might help. http://www.brownells.com/aspx/NS/schematics/schemmfg.aspx?schemid=399&m=2&mn=Browning%c2%ae&model=BPS+12-20+gauge+

jhm · « **Reply #2 on:** October 11, 2004, 02:00:04 PM »

James : Try this link http://stevespages.com/page7a.htm

JIM

james · « **Reply #3 on:** October 11, 2004, 05:33:06 PM »

thanks guys, I'll book mark the sites. I got the pieces back together and it functions fine. Pumps easier after the good cleaning.
James