Author Topic: Is it possible to.... (Read 649 times)

Brett · « **on:** October 29, 2004, 05:39:25 AM »

open up the full choke of a .410 barrel to make it modified choke? If so is this something I could do myself or would it have to be done by a smith? Thanks.

mitchell · « **Reply #1 on:** October 29, 2004, 01:34:47 PM »

u might want to ask this on the gunsmithing forum and let gunnut69 have a wack at it

Brett · « **Reply #2 on:** October 29, 2004, 04:47:24 PM »

Gunsmithing forum :?: Uh, I didn't know we had one. :oops: Guess I do now... I'll give it a try. Thanks Mitchell.

shaner · « **Reply #3 on:** October 30, 2004, 02:15:20 AM »

brett i think u might be wasting ur time doing that ? ive read a few reports on 410's and chokes , seems that they vary a little bit from skeet chokes to full at the same distances , they do open up a little more the bigger u go . but u also lose the length of the shot string, with the open chokes the last one i seen there was a different from skeet and full was 35bb outside the 20 circle different from the skeet to full?

ScatterGunner · « **Reply #4 on:** November 02, 2004, 07:03:26 AM »

a while back i was considering having a 410 bored to improved cylinder or maybe modified. to compare the two, i used my browning citori 410 with and changed between skeet chokes and modified chokes. on a skeet field, i shot consistant scores, within a bird or two, over four weekends of shooting, about 16 rounds or 400 birds, 200 with each choke.

i didn't bother having the choke on the handi opened up !

sg

Brett · « **Reply #5 on:** November 02, 2004, 11:46:04 AM »

Shanner, ScatterGunner, thanks for your input. After reading your comments and learning that it is a job best left to a gunsmith I have decided to leave my Topper as is. Thanks again for your replies.