Author Topic: Nice little add-on for the Lyman 450/4500  (Read 702 times)

0 Members and 1 Guest are viewing this topic.

Offline Cheyenne Ranger

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1111
Nice little add-on for the Lyman 450/4500
« on: November 26, 2004, 12:00:43 PM »
was looking around the net and found an ALF (Automatic Lube Feed) for the 450/4500.  You can see several pictures at:  http://www.castingstuff.com/cabinetree_loading_products.htm   go just over 1/2 way down.  If you use hard lube and a heater be sure to ask for the stronger spring. I mounted the ALF on top of the header--they say to mount it below the heater--I tried that and it didn't seem to work--lube didn't get hot enough.  I think the threaded rod draws heat away from the lube in the cylinder part.

In operation you turn the top till the spring starts to compress and then turn it two more times.  You can lube 15-20 bullets before having to do this again; this depends on the diameter of bullets and size of lube groove.  I didn't notice any lube leaking out of the machine nor getting under the bullet.  It speeds the process--what you have to decide is the cost of this worth the speed?  

I did notice that on my 4500 the handle will hit the threaded rod at full top extension.  I put a 1/4 nut at the bottom of the "U" bracket at the bottom and this reduced the throw enough to keep the handle from hitting.  Other than that it worked quite nicely.

  ÇR
SASS 48747L
RO II
Thunder River Renegades
SBSS #1170--OGB

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18263
Nice little add-on for the Lyman 450/4500
« Reply #1 on: November 26, 2004, 11:43:31 PM »
I actually helped him test the first couple prototypes and they do work pretty slick. Later i switched to star sizers and ill never go back. But for you guys that prefer the lymans this is a real good upgrade. With one of his prototypes i was sizing 50 .512 bullets before i had to adjust pressure. Like was said make sure you use a lube heater with hard lube or youll blow the bottom oring out pretty regularly. Jim sells alot of real high quality stuff
blue lives matter

Offline LAH

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 320
Nice little add-on for the Lyman 450/4500
« Reply #2 on: November 30, 2004, 06:23:42 AM »
Something I've found helpful is a rubber cord to hold the handle in up position while removing one bullet and adding another.
Joshua 1:9