« previous next »
Pages: [1]   Go Down

Author Topic: strip Norinco 1897 shotgun?  (Read 666 times)

0 Members and 1 Guest are viewing this topic.

Offline Horsefeathers

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 124
strip Norinco 1897 shotgun?
« on: December 02, 2004, 07:37:41 AM »
Need help with diassembling Norinco M1897 12 Ga.shotgun.  I followed instructions for a Winchester to no avail.   Removed two screws and a pin. Carrier is supposed drop out ,Then bolt is removed to rear. Tried this and nothing moves.  My bolt binds in frame midway to rear and takes a good pull to work the action. Iwould like to slick it up a bit.  Horsefeathers.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
strip Norinco 1897 shotgun?
« Reply #1 on: December 03, 2004, 07:21:15 AM »
I have not taken down the '97 copy produced by Norinco.  They are supposedly direct copies of the Winchester produced 97 but we all know how that goes.  I attached below a link to a parts blowup of the M97, what pin and screws have you removed?  Somewhere I've a takedown instruction sheet for the '97 but will have to look for it..  I will say that these are complex weapons and takedown is a chore...  There are a myriad of small parts and screws and many are unique..  never tear one down without a ral need...

http://stevespages.com/ipb-winchester-1897.html
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline EdSmith

  • Trade Count: (0)
  • Member
  • *
  • Posts: 61
strip Norinco 1897 shotgun?
« Reply #2 on: December 17, 2004, 08:52:08 PM »
did you remove the action slide hook ?
Logged
if it ain''''t broke,you ain''''t trying hard enough :D
Pages: [1]   Go Up
« previous next »