Author Topic: Question about cantilever scope mount ??? (Read 655 times)

NYH1 · « **on:** December 02, 2004, 10:02:37 AM »

I just picked up a brand new Remington 11-87 Premier 20 gauge. I got it with the 26 inch field barrel. The only slug barrel available is from Remington and its a 21 inch fully rifled barrel with rifle sights. I have to have a scope. I was wondering if I could have a cantilever mount put on this barrel? I'm not gonna drill and tap the receiver. Thank's

Bob_K · « **Reply #1 on:** December 02, 2004, 01:33:20 PM »

Remington has a clamp on cantilever that goes on the vent rib, plus there are after market versions that would silver-braze on a plain barrel. Check the Brownells catalog.

NYH1 · « **Reply #2 on:** December 02, 2004, 01:46:23 PM »

Quote from: New York Hunter

I was wondering if I could have a cantilever mount put on this barrel?

Thank's Bob_k, I should have been more specific, I would like to have the cantilever mount put on the 21 inch rifled barrel. I will check Brownells though!

Will_C · « **Reply #3 on:** December 03, 2004, 12:25:39 PM »

How about trying a Hastings barrel? I am quite sure that they offer a 20 gauge barrel with a cantilever mount.

NYH1 · « **Reply #4 on:** December 03, 2004, 01:09:45 PM »

Will_C, Hastings makes two different barrels for a Remington 1100 20 ga. but nothing for a 11-87 20 ga.

Will_C · « **Reply #5 on:** December 04, 2004, 12:21:58 PM »

New York Hunter;
My bad :oops:
Will