« previous next »
Pages: [1]   Go Down

Author Topic: Tang Safety 6mm  (Read 601 times)

0 Members and 1 Guest are viewing this topic.

Offline RWH24

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 156
  • Gender: Male
Tang Safety 6mm
« on: December 11, 2004, 02:51:32 AM »
While at a gun shop yesterday I saw a Ruger M-77 tang safety 6mm rifle w/rings on the rack. What rate of twist does this gun have? Better for lite or HVY bullets?
Bore needs cleaning, lands look sharp/square. It also has a very nice trigger.
This is a consignment gun :?

Thanks
RWH24
Logged

Offline Omaha-BeenGlockin

  • Moderator
  • Trade Count: (0)
  • A Real Regular
  • *****
  • Posts: 864
Tang Safety 6mm
« Reply #1 on: December 11, 2004, 08:11:03 AM »
Don't know about the old ones----the new ones are showing a 1 in 9 twist.
Logged

Offline RWH24

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 156
  • Gender: Male
Tang Safety 6mm
« Reply #2 on: December 12, 2004, 03:12:08 PM »
Okay then. Long or short action??
$275.00 for the gun, thinking about buying to re-barrel in another calibre.  :wink:
I have a 243 already :roll:
Logged

Offline Omaha-BeenGlockin

  • Moderator
  • Trade Count: (0)
  • A Real Regular
  • *****
  • Posts: 864
Tang Safety 6mm
« Reply #3 on: December 12, 2004, 07:18:30 PM »
I'm thinking it would have to be a long action----since the 6mm is longer than the short action calibers------unless Ruger made an intermediate action at the time????
Logged

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26945
  • Gender: Male
Tang Safety 6mm
« Reply #4 on: December 12, 2004, 08:46:00 PM »
I'm not sufficiently aware of what Ruger did or does make but the 6MM Remington, .257 Roberts and 7x57 share the same 57MM long case. All are chambered in short actions or have been by Remington. Altho I personally agree a longer (than Remington short action) makes sense to me.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline George Foster

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 396
Tang Safety 6mm
« Reply #5 on: December 13, 2004, 01:15:02 AM »
RWH24,

My Ruger 77 6MM is a short action.  It is one of of the new ones so I am not sure if the tang safe model was based on the same length action but I would think so.
Logged
Good Shooting,
George

Offline Val

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 846
Ruger M77 Tang Safety
« Reply #6 on: December 13, 2004, 04:06:49 AM »
I have a 243 Ruger M77  Tang Safety and it's a short action. It's a good accurate rifle based on the 308 cartridge case.
Logged
Hunting and fishing are not matters of life or death. They are much more important than that.

Offline RWH24

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 156
  • Gender: Male
Tang Safety 6mm
« Reply #7 on: December 14, 2004, 11:25:26 PM »
Thanks for the replies:

I have a Tikka in 243 now. I was looking at th Ruger as a project gun for a re-barrel to ?? calibre. Would want a L/A receiver.

Again Thanks

Randy
Logged

Offline Carl l.

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 249
  • Gender: Male
  • Hunting,Fishing,Camping and Woodworking
Tang Safety 6mm
« Reply #8 on: December 15, 2004, 05:10:37 AM »
I have a .257 in a M77, tang safety, made in 1970 and it is a long action. They may have made both short and long actions. Carl L.
Logged
Pages: [1]   Go Up
« previous next »