« previous next »
Pages: [1]   Go Down

Author Topic: New to the board. Got a load question.  (Read 1105 times)

0 Members and 1 Guest are viewing this topic.

Offline .45 COLT

  • Trade Count: (1)
  • Contributor
  • ***
  • Posts: 319
New to the board. Got a load question.
« on: November 27, 2002, 07:02:38 AM »
I'm not going to post these loads because they are more than a little warm, but this link should give you about what you're looking for.

http://www.handloads.com/loaddata/xcaliber.htm

I've used this data, but make sure of your guns condition before firing.

Note: The Herco load is hotter than I would try.
Logged
On the 19th of April, 1775, a tyrannical government sent an army to disarm its citizens. They ran into a touch of trouble.

Offline Loader 3009

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 461
Re-loads
« Reply #1 on: December 07, 2002, 01:03:41 PM »
Please, please, please invest in at least one reloading manual.  Midway Shooting Supply is a great source.  Never attempt to reload without a manual at hand.  Always double check others advice with your manual(s) before attempting to load.  I would stay away from hot loads as they abuse your gun.  Paper targets and bad guys will never know the difference.
Logged
Don't believe everything you think.
Pages: [1]   Go Up
« previous next »