« previous next »
Pages: [1]   Go Down

Author Topic: Anyone have any experience with the AMT or Lyman Autoscale??  (Read 885 times)

0 Members and 1 Guest are viewing this topic.

Offline EDG

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 176
Anyone have any experience with the AMT or Lyman Autoscale??
« on: February 08, 2003, 06:16:49 PM »
I bought a used bargain today. Anyone have any comments - good , bad or ugly. I bought it to use with the coarse extruded powders IMR type powders.
 Ed
Logged

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
Anyone have any experience with the AMT or
« Reply #1 on: February 09, 2003, 11:10:25 AM »
A freind of mine has the lyman, The only complaint is that its slow. Solved that problem by hand throwing a scoop of powder a couple of grs. shy of the programed load and it finnished it off pretty quick.  KN
Logged
Pages: [1]   Go Up
« previous next »