Author Topic: Three new barrels for sale (GunsAmerica) (Read 2071 times)

John N · « **on:** April 04, 2005, 03:39:36 AM »

Check out these 3 barrels for sale at http://www.gunsamerica.com/fast.cgi?guncat=1246.

There's a 3/4 scale reproduction 3" ordance rifle cannon 55" long and weighing 340lbs for $1610, a 2/3 scale field cannon barrel that is 43" long, weighs 250 pounds, and has a steel lined 2 1/4" bore (seamless???) for $1100, and a 1/2 scale napoleon barrel 36" long weighing 150lbs and a 3/16" liner for $795.

Might be worth checking out, especially if the liners are seamless.

CAV Trooper · « **Reply #1 on:** April 04, 2005, 09:09:14 AM »

Wonder if that's Cannon Mike's that's listed in the "Where to find Blackpowder Cannons and shooting supplies" sticky?

guardsgunner · « **Reply #2 on:** April 04, 2005, 09:12:37 AM »

Some who was willing to make a fool of himself, might state that they look a lot like Herns Iron works barrels that someone is trying to resell for a profit. Then again he could be mistaken.

John N · « **Reply #3 on:** April 04, 2005, 10:03:45 AM »

guardsgunner,

Good Catch! I did a side by side comparison and it sure looks like you are right. Same specs and apperance. Only the prices are higher, much higher than Hern. I didn't know Hern's barrels have steel liners. I thought I read somewhere on this board that's not the case.

guardsgunner · « **Reply #4 on:** April 04, 2005, 10:30:07 AM »

I here they come standard with a 1/4 " liner but will cast around a liner that you provide.
That would make them the cheapest way into full scale civil war artillery.

intoodeep · « **Reply #5 on:** April 04, 2005, 01:04:10 PM »

Quote

Wonder if that's Cannon Mike's that's listed in the "Where to find Blackpowder Cannons and shooting supplies" sticky?

CAV Trooper,

They are two different people. Cannon Mike is from Oregon and the person listing (Mike's Cannon) on Guns America has an area code (406) from Montana. Also, I belive that all of Cannon Mike's stuff is machined not cast. Hope that helps.

CAV Trooper · « **Reply #6 on:** April 04, 2005, 01:25:37 PM »

intoodeep,

Thanks. I knew that tubes from Mike's Cannon were machined but thought maybe he was branching out.

Looking again, I have to agree those tubes look just like Hern products.

Sorry, but after seeing pictures in the SBR catalog of how FUBAR a tube can get when the sleeve is cast in place, I'll never buy one that isn't cast solid and then sleeved after being drilled.

Evil Dog · « **Reply #7 on:** April 05, 2005, 03:33:05 AM »

Dixie Gun Works also sells barrels from Hern Iron Works at a rather hefty profit. I have a half scale Napoleon from Hern and absolutely love it.... will be buying their Coehorn barrel within a month or two.