« previous next »
Pages: [1]   Go Down

Author Topic: Handi Stock  (Read 381 times)

0 Members and 1 Guest are viewing this topic.

Offline 6-24x42

  • Trade Count: (0)
  • Member
  • *
  • Posts: 92
Handi Stock
« on: April 14, 2005, 03:55:24 AM »
Hey guys,
I found a whole bunch of wood in my garage that is just about the right width to try to fabricate a stock. This hobby has peaked my interest lately and I have two questions:

1.) How does the rear stock attatch to the action?
2.) Does anybody have some websites that add some insight into stock fabricating? :?
Logged
Hustle, Desire, Discipline :gun4:

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Handi Stock
« Reply #1 on: April 14, 2005, 05:12:15 AM »
The stock is attached by about a 3/8"x5" bolt within the stock, if you remove the 2 phillips head screws to remove the butt pad, you'll see the hole, the head of the bolt is 9/16", you'll need a long 3/8" drive extension for your ratchet.
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline 6-24x42

  • Trade Count: (0)
  • Member
  • *
  • Posts: 92
Handi Stock
« Reply #2 on: April 14, 2005, 07:02:12 AM »
Thank ya sir. I appreciate it 8)
Logged
Hustle, Desire, Discipline :gun4:
Pages: [1]   Go Up
« previous next »