Author Topic: magnum or standard primer for reduced loads? (Read 440 times)

adam · « **on:** April 15, 2005, 10:52:46 PM »

Hi
which one is the best choice for using when reloading with reduced loads ? isn't that better with mags when a 3030 case is only loaded with about 10 gr powder to assure better ignition?
cheers
adam

jgalar · « **Reply #1 on:** April 16, 2005, 01:57:55 AM »

I use standard primers with unique and 2400 with excellant results.

Redhawk1 · « **Reply #2 on:** April 16, 2005, 02:03:49 AM »

I have never understood the reduced load theory. I buy a gun to shoot the round it was designed for at full power. I practice with my guns as I would be shooting them for hunting. I don't want to have to adjust my scope going from practice loads (reduced loads) to my hunting load.

I know I did not answer your question and this is no way a flame to you. I just don't understand the theory behind it.

.45 COLT · « **Reply #3 on:** April 16, 2005, 03:52:47 AM »

Standard primer - Cast bullet - Unique - .30-30

Works for me.

adam · « **Reply #4 on:** April 16, 2005, 05:54:09 AM »

Hi Redhawk
It is a great joy to plinking with my 3030s a ful load costs more and is needlless more powerful. my eyes are great i don't use scopesight i just regulate the ironsight

adam

Redhawk1 · « **Reply #5 on:** April 16, 2005, 06:28:46 AM »

Quote from: adam

Hi Redhawk
It is a great joy to plinking with my 3030s a ful load costs more and is needlless more powerful. my eyes are great i don't use scopesight i just regulate the ironsight
adam

I just like full power loads myself. But I hope you get the information you need.

lilabner · « **Reply #6 on:** April 16, 2005, 07:53:11 AM »

You are probably concerned about igniting the powder thoroughly. One approach is to put a filler in the case to keep the powder close to the primer. Or, you can tip the rifle back to position the powder charge just before you shoot. I would use a standard primer.

quickdtoo · « **Reply #7 on:** April 16, 2005, 09:48:56 AM »

I'm shooting a peep sighted 45-120-3¼" rechambered H&R Buffalo Classic using 41-43grs of XMP5744 which is an AA recommended load, powder position makes no difference in this huge case which is less than 50% full using CCI 250 mag rifle primers and no filler. I get 1½-2" 100yd groups regardless of whether the powder is in the front or rear of the case, or just level. The "little" cartridge on the left in the pic is a 45-70.