Author Topic: New reloader has questions... (Read 351 times)

astrix · « **on:** July 15, 2005, 05:06:57 AM »

Howdy,just getting started in loading for a 44 mag.
barrel on my Encore.As far as brass goes,are the
brands interchangeable or do I need to stick to the
brand used in particular recipes in my manuals?
I also would like opinions on bullets in the 240-300
grain range out of a 20" barrel.Thanks for any and
all suggestions on powders for both plinking and
hunting loads as well.
Gary

stimpylu32 · « **Reply #1 on:** July 15, 2005, 06:00:56 AM »

As far as brass goes , they are interchangeable as long as they are the same cal. Don't try to reload cci blazers or steel cases though .

The 44 mag is a perdy good all around round for the contender , some seen to like the lighter bullets and some like heavy ones you will have to find what it likes. here is a link to some real good load data.

http://stevespages.com/page8c.htm

Steve has a lot of knowledge to share.

If you need anymore help all you have to do is ask :grin:

ricciardelli · « **Reply #2 on:** July 15, 2005, 07:48:15 AM »

:oops:

astrix · « **Reply #3 on:** July 15, 2005, 04:49:27 PM »

Thanks for the info guys.I'm sure I'll have more questions
as I get further into this.
Great site Steve,lot's of great info there.I think I'll get
a good variety of bullets and powders and see what shoots
the best for me.Thanks again,
Gary