Author Topic: YUGO 48A MAUSER SCOPE MOUNT (Read 453 times)

ONE HOLE 4570 · « **on:** August 03, 2005, 12:03:07 PM »

Does anyone make a drill & tap scope ,mount for a yugo 48a. Want to keep 1 stock & sporterize the other. Don't want a clamp on just a good old fashion mount that bridges the action

Thanks

Mikey · « **Reply #1 on:** August 04, 2005, 03:21:39 AM »

I think the Yugos take the standard Mauser 98 scope mounts, and those are plentiful. I just had my Husquavarna 98/8mm drilled and tapped and finding bases wasn't a problem. Right out of Brownells, I think. HTH. Mikey.

Badnews Bob · « **Reply #2 on:** August 05, 2005, 12:30:34 PM »

The one piece K98 mount wont fit, Its to long. I've been looking at some two piece mounts for the .376 Steyr I'm haveing built. Haven't found a bridged one yet.

ONE HOLE 4570 · « **Reply #3 on:** August 09, 2005, 06:22:35 AM »

ok 2 piece it is. Has anyone seen a weaver type 2 piece base all I can find is the turn in type mounts

vlado_t · « **Reply #4 on:** August 09, 2005, 06:21:50 PM »

Leupold Mauser 98 - one piece would fit. I have it on 3 of my M48s. your M48a has the same receiver

1911crazy · « **Reply #5 on:** August 10, 2005, 10:29:19 AM »

I know the 98 bolt is longer than the 48 bolt but i'm not sure about the reciever but there are 3 different length bolts on the large ring mausers. If i remember correctly one is almost 6" and i think there is a 5 3/4" and a 5 1/2" I got into this years ago, its the length of the throw. Maybe the 6" reciever doesn't fit the one piece scopemount where the 5 3/4" & 5 1/2" will use the one piece base.