Author Topic: 30-30  (Read 702 times)

0 Members and 1 Guest are viewing this topic.

Offline dholepuncher

  • Trade Count: (0)
  • Member
  • *
  • Posts: 28
30-30
« on: February 23, 2003, 03:05:39 PM »
i have a 30 30 12 inch super contender barrel i plan to shoot hogdgons powder with 125 ballistic tip, i was thinkin 322 cause i have lot of it and it burns faster than varget and the barrel is only twelve inches, any thoughts are welcolme

Offline GREYGHOSTt

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 101
30-30
« Reply #1 on: February 26, 2003, 02:56:44 AM »
looks like a good idea
third eye blinds the other two.

Offline Hopalong7

  • Trade Count: (20)
  • Senior Member
  • *****
  • Posts: 1673
  • Gender: Male
30-30
« Reply #2 on: February 26, 2003, 04:45:36 AM »
dholepuncher,  My 30-30 barrel w/ 125BT loves Rel7 but 322 should do well.  I used to try to out-guess my barrel...shorter barrel...faster powder...etc, and sometimes it worked.  However, over the years I've found that for bottle neck cartridges, the same powder thats best in rifle barrels is often still the best one in pistol barrels ( 14-16" )...10"...maybe not...12"...I don't know.  But then not knowing means more reason to shoot MORE....YES.
  By the way, you sent me a PM a week or so back and I tried to get back to you but I think I blew it.  Sorry, If you remember hollar back and I'll try to do better.   GOOD SHOOTIN',  Walt   :D    :D    :D

Offline PaulS

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1120
30-30
« Reply #3 on: February 26, 2003, 12:33:53 PM »
dholepuncher,
Hopalong is correct in that the same powders that give the highest velocities in long barrels will give the highest velocity in short barrels. The reason for this is that the bullet weight and capacity of the cartridge determine the powder that will give the highest velocity from what ever barrel length you have.

PaulS
PaulS

Hodgdon, Lyman, Speer, Sierra, Hornady = reliable resources
so and so's pages on the internet = not reliable resources
Alway check loads you find on the internet against manuals.
NEVER exceed maximum listed loads.