Author Topic: re: difficulty assembling Muzzys (Read 524 times)

Type99 · « **on:** August 21, 2005, 01:37:37 AM »

Hello...

I'm having a hell of a hard time putting together the Muzzy 3-blade broadheads I just bought. I have never used this brand before.

Is there a trick to putting these together? I am using the assembly instructions on the back of the bubble pack, which really don't tell you much. I can't seem to get the hang of it. I don't think it should be this difficult.

What can you tell me about putting these together?

Thanks in advance for your advice,
Gary

Mike357mag · « **Reply #1 on:** August 21, 2005, 06:25:27 AM »

http://www.losthunter.com/artdisp.asp?artid=29&arttitle=3-Blade+Broadhead+Assembly+Made+Easy

basically the looking into the front of the broadhead body there is a Kind of "Y" shape made from the three slots for the blades each blade will be in two slots each, the angle bent piece will be in a slot along with a sharp blade from a neighboring blade. Do not insert the blades all the way it will be too tight to put them all in, only insert them about 3/4 of an inch until they are all in and push them all the way in at the same time.

Hope this helps. Muzzys are great broadheads I use them in all my bows.

Mike H

Type99 · « **Reply #2 on:** August 21, 2005, 07:09:48 AM »

Hello Mike...

Thanks for the link. That made it easy.

Once I got the hang of it, the rest was pretty simple.

Thanks again,

Gary

Redhawk1 · « **Reply #3 on:** August 21, 2005, 07:28:06 AM »

I was going to say, it is not to hard. Once you get the hang of it. I use Muzzy's also.