Author Topic: Scoping (Read 610 times)

ScoutMan · « **on:** September 01, 2005, 11:21:55 AM »

I have a bull barrel Ruger Mark II . I would like to scope it for small game hunting. Any suggestions on type of mounts and rings. I would prefer not to drill and tap.

Any suggestons?

SM

Dave in WV · « **Reply #1 on:** September 01, 2005, 02:55:23 PM »

I had a stainless MK II bull barrel and now have a target slab side MK II with a dot sight built like a scope. If I had to do it over I'd get a Docter Optic dot sight and a mount for a MK II and kept the bull barrel. I liked the feel of the 5.5" bull barrel and the Docter Optic sight weighs so little it would still be as handy for hunting.

CraigJS · « **Reply #2 on:** September 11, 2005, 03:31:52 PM »

How about something like these SoLow rings.. http://www.solow.com/solow.htm
They work very well with dot sights. Doctors are nice sights but pricey!

WNY_Whitetailer · « **Reply #3 on:** September 12, 2005, 06:47:21 AM »

You must have an older MkII that is not drilled and tapped...If that is the case then Weigand Combat Handguns, Inc makes a non d&t scope mount for your gun...Check out the link(scroll down the page) as well as the pic:

http://jackweigand.com/rm2fd.html

If your MkII is drilled and tapped then Jack makes a scope base for you too...It is on the same link listed above.

I have a Jack Weigand Scope Mount on my Ruger Super Blackhawk Hunter and my Browning Buckmark and they are rock solid...I would recommend any of Jack's work to anyone looking for a great scope rail.

Check him out...