« previous next »
Pages: [1]   Go Down

Author Topic: Barrel tapers and finish  (Read 288 times)

0 Members and 2 Guests are viewing this topic.

Offline bajabill

  • GBO Supporter
  • Trade Count: (5)
  • A Real Regular
  • *****
  • Posts: 712
Barrel tapers and finish
« on: September 28, 2005, 06:18:40 AM »
I got my new barrels and noticed the 223, 24" bull (Ultra) has a more polished finish to it.  The 357mag and my original 243 22" Bull, both stamped as handi rifles; both have a rougher, spun finish.  Is this a common difference with the "ultra" barrels compared to the "handi rifle" barrels.

Also, the taper on the 357 is not too differnet from the bull barrels.  I havent been able to measure them yet.
Logged

Offline Mac11700

  • GBO Supporter
  • Trade Count: (34)
  • Senior Member
  • *****
  • Posts: 6875
Barrel tapers and finish
« Reply #1 on: September 28, 2005, 06:54:50 AM »
I recently just got my 25-06 barrel back...and it isn't marked Ultra...just handi rifle...so I just called and spoke with Gordan at NEF...he says they are reducing the amount of stampings on the new barrels...and they all will eventually say just Handi Rifle on it...perhaps they are looking to cut cost on the finishes and roll stampings?Mine isn't polished as nice as my original...but the taper is the same...

Mac
Logged
You can cry me a river... but...build me a bridge and then get over it...

Offline bajabill

  • GBO Supporter
  • Trade Count: (5)
  • A Real Regular
  • *****
  • Posts: 712
Barrel tapers and finish
« Reply #2 on: September 29, 2005, 11:21:03 AM »
OD at end of barrel

357 (22")   .74"
243 (22" bull)   .81"
223 (24" bull)     .78"

I havent checked the 32" 45/70 yet
Logged
Pages: [1]   Go Up
« previous next »