« previous next »
Pages: [1]   Go Down

Author Topic: Ruger 77 questions  (Read 419 times)

0 Members and 1 Guest are viewing this topic.

Offline Reloader

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 155
Ruger 77 questions
« on: October 09, 2005, 11:38:53 AM »
Somebody pointed me to this forum as the place to go to get answers to the following question.  What is the proper way for putting a wooden stock on a Ruger 77 as far as which screw to tighten first and how much each screw should be tightened?

Any help would be appreciated.

Thanks :oops:
Logged
If I can make it go bang it can't be that hard to do.

Offline Dave in WV

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2162
Ruger 77 questions
« Reply #1 on: October 09, 2005, 12:16:58 PM »
Go to Ruger's site and select "Safety". You can download the owner's manual or just view it. It has the directions you're looking for. I will add the center screw doesn't need tightend as much as the front and rear ones but must be snug enough to hold the front of the trigger guard in place.
Logged
Setting an example is not the main means of influencing others; it is the only means
--Albert Einstein
Pages: [1]   Go Up
« previous next »