Author Topic: Have a question on my new 1894C (Read 680 times)

Shuttleman · « **on:** October 11, 2005, 03:50:07 AM »

I just picked up a new 1894C yesterday and noticed that where the carrier assembly front tab goes through that rectangle cut out on the bottom front of the receiver, mine sits to the left side and hits a bit when the action is worked. Is this how they are made or should it be centered in the receiver cut-out?

Thanks, Tom

REDDR · « **Reply #1 on:** October 11, 2005, 06:23:16 AM »

Tom:

Congratulations on your new 1894C! Great rifle, lots of fun to shoot.

On mine, the tab you mentioned is centered. Maybe something is either bent or not aligned correctly. Does the action cycle ammo ok?

Take care,
REDDR

Shuttleman · « **Reply #2 on:** October 12, 2005, 04:14:47 AM »

REDDR, after taking it appart it has a bent carrier. As I just got it on Manday I am taking it back to the store for an exchange.

Also, as all my 38/357 ammo is jacketed round nose, what are some good plunken ammo in flat point?
Thanks, Tom

Jerry Lester · « **Reply #3 on:** October 12, 2005, 06:49:33 PM »

That's a shame about that carrier.

Some good, fairly cheap, but usually accurate plinking ammo in either 38 special, or 357 magnum is the Winchester "Win-Clean" stuff. It burns very clean, and shoots good in most guns.

It's tough to beat for plinking, or target shooting, but it doesn't expand at all in 38 specials, and very little in 357 magnums on game. It's great for small game(especially 38's), but it'll leave you with a wounded animal if you tackle anything bigger than a coon with it.

Shuttleman · « **Reply #4 on:** October 13, 2005, 10:51:32 AM »

Jerry, thanks for the info. What loads do you use for hunting?
Tom