« previous next »
Pages: [1]   Go Down

Author Topic: Anyone make a hooded front sight  (Read 423 times)

0 Members and 1 Guest are viewing this topic.

Offline iiibbb

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 279
Anyone make a hooded front sight
« on: October 27, 2005, 06:17:54 PM »
Does anyone know if anyone makes a hooded front sight out there?  I want to mate a rear peep sight with a front hooded sight.

Thanks
Logged

Offline armory414

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 339
Anyone make a hooded front sight
« Reply #1 on: October 31, 2005, 04:00:03 AM »
I don't have a link, but you could look into the Bomar sights used by the IHMSA shooters. . .an alternative is to remove the existing front site, and have a gunsmith cut a dovetail and use an Anschutz or Lyman front site with the interchangeable pins. . .
Logged

Offline dgii

  • Trade Count: (0)
  • Member
  • *
  • Posts: 39
Anyone make a hooded front sight
« Reply #2 on: November 01, 2005, 10:41:55 AM »
Go to http://www.midwayusa.com/, they should have some ideas for you.  

You could also try www.brownells.com.  

Will probably depend on taper of barrel, if you can get a low enough front to go with the peep sight.
Logged

Offline 1stshot

  • Trade Count: (0)
  • Member
  • *
  • Posts: 35
  • Gender: Male
hooded front sight
« Reply #3 on: November 05, 2005, 05:36:23 PM »
how about a williams front ramp and hood. the older contenders had a williams front sight ramp withe hood groove and i i did was found hood at a gun show and slid it on!! easy enough. that is if that is what you wanted!
Logged
Pages: [1]   Go Up
« previous next »