« previous next »
Pages: [1]   Go Down

Author Topic: CZ 527 threads  (Read 402 times)

0 Members and 1 Guest are viewing this topic.

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
CZ 527 threads
« on: November 14, 2005, 02:21:26 AM »
Anybody here know what the barrel threads are on a CZ 527? I'd like to put together one in 6.5mm PPC but my lathe can't cut metric threads so it would be good to find out before I go too far thinking about it.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
CZ 527 threads
« Reply #1 on: November 14, 2005, 04:52:39 AM »
I'm sorry but haven't rebarreled one and don't have any idea.. That sounds like a great idea but are you certain the 527 will handle that case diameter.. The PPC's are built on much larger case diameters than the 22 Hornet/223 diameter commonly used in the 527. They do put up the 7.62x39 so I suppose it might work.. Is there sufficient bolt face diameter for the PPC casehead?
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
CZ 527 threads
« Reply #2 on: November 15, 2005, 02:18:34 AM »
Yep. I plan on starting with one in 7.62X39 so the only change would be the barrel and probably the feed lips on the mag. It's a single stack center feed type, but the PPC case is a lot fatter in the front so it'll probably need some attention. I'm hoping it'll be a nice lightweight rifle for tactical matches with a lot more long range punch than the original caliber. I've been so impressed with what the 6.5 Grendl does that I want to try my own version.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
CZ 527 threads
« Reply #3 on: November 15, 2005, 11:41:32 AM »
I was thinking the PPC rounds were larger in diameter than a Russian 30 cal short. Are you certain the CZ has the bolt face to allow for it the be expanded to contain the larger PPC case head?
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
CZ 527 threads
« Reply #4 on: November 16, 2005, 02:19:53 AM »
Yep. They're all made off the .220 Russian case. Same exact case head, so no bolt work would need to be done.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."
Pages: [1]   Go Up
« previous next »