« previous next »
Pages: [1]   Go Down

Author Topic: 6mm-284  (Read 483 times)

0 Members and 1 Guest are viewing this topic.

Offline maggot

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 181
6mm-284
« on: March 05, 2003, 07:04:33 PM »
Does anyone use factory 6.5mm-284 brass and size it down to 6mm-284.I think this might be faster than using 284 brass.I'm not sure the shoulder angle is the same.Also can you recommend some good dies,not to expensive?Maybe some load data?
Logged
Pages: [1]   Go Up
« previous next »