« previous next »
Pages: [1]   Go Down

Author Topic: Thought I found a reason to replace my Lee measure  (Read 337 times)

0 Members and 1 Guest are viewing this topic.

Offline MnMike

  • GBO Supporter
  • Trade Count: (0)
  • Contributor
  • *****
  • Posts: 493
Thought I found a reason to replace my Lee measure
« on: December 15, 2005, 05:08:10 PM »
My Lee measure is crude, but it wotks. I have been wanting to find an excuse to replace it. The other night it started throwing unstable charges. I did the rational thing, I whacked it. It then got hard to operate for a couple of cycles. I whacked again. Now it wouldn't deliver any powder. I tried a few things and then took off the drop tube. A .243 bullet came out. It now works fine. I guess I will have to use it for a while more. I must have pulled a bullet and poured the contents of my bullet puller into the powder container. DUMB.

mike
Logged
Mike Ellestad

Offline PaulS

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1120
Thought I found a reason to replace my Lee
« Reply #1 on: December 15, 2005, 08:42:38 PM »
MnMike,

What kind of primer do you have to use to touch off that big hunk of lead to get it to burn?   :-)
Logged
PaulS

Hodgdon, Lyman, Speer, Sierra, Hornady = reliable resources
so and so's pages on the internet = not reliable resources
Alway check loads you find on the internet against manuals.
NEVER exceed maximum listed loads.

Offline williamlayton

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 15415
Thought I found a reason to replace my Lee
« Reply #2 on: December 16, 2005, 03:16:53 AM »
It must be a secret!!!
I do not think I would try it, no matter the recipe!!!! :eek:  :shock:  :wink:
Blessings
Logged
TEXAS, by GOD

Offline MnMike

  • GBO Supporter
  • Trade Count: (0)
  • Contributor
  • *****
  • Posts: 493
Thought I found a reason to replace my Lee
« Reply #3 on: December 18, 2005, 04:00:05 PM »
I got an e-mail from a company that thought they could help. I then noticed they were located in Chernobyl, Russia. I guess I'll pass.

back to using pure Varget,

mike
Logged
Mike Ellestad
Pages: [1]   Go Up
« previous next »