Ruger laminate stock without cheek piece

[NoKness]

Hi Guys,
   I am in the planning stages for my first custom/or semi custom rifle and I am looking for a laminated stock for a ruger M77 tang safety that is very close in configuration to the factory stock. I like a high straight stock without a cheekpiece and narrow through the grip.

I see both Boyds and Richards Microfit offer stocks at very reasonable prices but both have the cheek pieces. Is there another source that I should know about?

NoKnees

[gunnut69]

I would likely just remove the cheek piece from a stock I liked. As with thinning the grip, that's a fairly seasy alteration..  Tightening the grip curvature can be a lot more difficult. You can also work fromm a blank if you wish. Laminated blanks are available..  You might also check out a place called 'ElkRidge' for you laminated stock.

[jhm]

NoKnees :  I have a old ruger tang safety 30-06 wiuth a factory green lamanated (factory) stock on it, you might contact them and see who made the stocks for this particular rifle as I cant seem to locate it in any of their cataglogs I looked at or in the blue book either, if their is any other info on it that you might need contact me via PM, HTH     JIM