Author Topic: Older Star Sizer  (Read 730 times)

0 Members and 1 Guest are viewing this topic.

Offline Turbo

  • Trade Count: (0)
  • Member
  • *
  • Posts: 44
Older Star Sizer
« on: March 18, 2003, 06:38:38 PM »
I bought a Star Sizer on Ebay. It is an older model made in San Diego, California. My question is relative to lube leakage from the top and bottom of the die.  I heard that new Star sizers from Magma Engineering have "O" rings around the die. My sizer does not appear to be set up for "O" rings.

I need to order dies from Magma, so I haven't been able to try it yet. Do I need to do anything relative to preventing lube leakage? I'll start using a soft lube made from 50% Sta-Lube Extreme Pressure Moly Grease and 50% Beeswax.

Thanks!
If it isn't fun, it probably isn't worth doing.

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18267
Older Star Sizer
« Reply #1 on: March 19, 2003, 12:28:06 AM »
I have an older one and it doesnt leak a bit. Maybe your using to much lube pressure.
blue lives matter

Offline Turbo

  • Trade Count: (0)
  • Member
  • *
  • Posts: 44
Lloyd, Thanks for the reply
« Reply #2 on: March 19, 2003, 03:44:14 AM »
I may have been worried about nothing. I'll certainly give it a try as soon as I get my dies from Magma.

Do you normally use a soft lube or do you use a hard lube and a heater?

Thanks!
If it isn't fun, it probably isn't worth doing.

Offline JBMauser

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 391
Star
« Reply #3 on: March 19, 2003, 09:35:02 AM »
write to : coffeyn1@juno.com  He will put you in touch with the Star forum/user group.  He used to be the largest dealer for Star on the west coast.  He also sells parts and original dies for older Star sizers.  He is a wealth of info.  Best of luck JB.

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18267
Older Star Sizer
« Reply #4 on: March 19, 2003, 01:08:33 PM »
soft
blue lives matter

Offline pjh421

  • Trade Count: (0)
  • Member
  • *
  • Posts: 44
Older Star Sizer
« Reply #5 on: May 05, 2003, 09:52:01 PM »
Yep, too much spring tension.  I've got O-rings but too much pressure makes mine ooze lube in front of the SWC shoulder and also around the base edge of the bullet.  Use a lube heater and only enough spring tension to get the job done.

Paul