« previous next »
Pages: [1]   Go Down

Author Topic: AR carry handle mount  (Read 547 times)

0 Members and 1 Guest are viewing this topic.

Offline simplicity

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 574
  • Gender: Male
AR carry handle mount
« on: March 06, 2006, 08:47:49 AM »
Anyone Know of a good scope mount for the carry handle on a AR that doesn't constantly loosen up and will hold a scope on it's zero?

Another Question  With a A3 upper how much of a bother does the front sight tree make in the scope's sight picture?
Logged

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
AR carry handle mount
« Reply #1 on: March 06, 2006, 01:18:36 PM »
I have one of the luepolds that is pretty much like all the others. One thumbscrew in the middle. I drilled and taped the handle/scope mount for two small flat head screws. That works really well.   KN
Logged

Offline Center Shot

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
AR carry handle mount
« Reply #2 on: May 03, 2006, 04:05:37 AM »
I just bought a Rock River mount for mine to use when I work up loads for it and varmint hunt. It was of higher quality than I expected for $49, and the rings are integrated into the base. I do not know about returning to zero after removing it, but plan on finding out tomorrow when I go to the range to test some new loads. I see no reason why it should not return to zero as it is a good fit.
Logged

Offline Center Shot

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
AR carry handle mount
« Reply #3 on: May 04, 2006, 02:07:05 PM »
Went to range today and reinstalled Scope mount (screws hand tight), and the zero was right were it was when the scope was removed. I would highly recommend the Rock River Hi Riser mount.

http://www.rockriverarms.com/item-detail.cfm?ID=AR3629&storeid=1&image=mnts4.gif&CFID=12506629&CFTOKEN=57672871
Logged
Pages: [1]   Go Up
« previous next »