« previous next »
Pages: [1]   Go Down

Author Topic: Forearm screws backing out  (Read 767 times)

0 Members and 1 Guest are viewing this topic.

Offline K.K

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 533
Forearm screws backing out
« on: March 29, 2006, 01:36:43 PM »
Anyone had a problem with their forearm screw backing out?  I was on a muzzleloader hunt in Illinois last season and I had to keep checking and tightening the darn things.  I know that locktite is out. any suggestions?
Logged

Offline RWD

  • Trade Count: (1)
  • Member
  • *
  • Posts: 93
Forearm screws backing out
« Reply #1 on: March 30, 2006, 11:35:34 AM »
try some white plumbers tape. Works well on screw on muzzle brakes as well.
Logged

Offline Grumulkin

  • Trade Count: (33)
  • Senior Member
  • *****
  • Posts: 2028
    • http://www.orchardphoto.com
Forearm screws backing out
« Reply #2 on: March 30, 2006, 01:41:02 PM »
You could try lockwashers.
Logged

Offline TC2

  • Trade Count: (0)
  • Member
  • *
  • Posts: 29
  • Gender: Male
Forearm screws backing out
« Reply #3 on: March 30, 2006, 04:31:12 PM »
Try little clear finger nail polish.  It will hold the screw but will let go easily when you change out the forearm.
Logged
------------------------
TC2

Offline HawkEyeEarl

  • Trade Count: (2)
  • Member
  • *
  • Posts: 54
Re: Forearm screws backing out
« Reply #4 on: August 04, 2006, 05:51:26 PM »
I have shot my encore 25-06 1 session. It was a good shooter. But the screws came out in about 40 rounds.
I shot my encore 375 h&h magnum 1 session. It was great by the way. But the screws came out in 24 rounds.

I have ordered several sets of screws for these encores.
It looks as if will need them.

Does anyone know if the screws are softer than the barrels?
That is will the screw threads give way wiithout damaging the riifle threads?

How tight do you turn screws?
Do you check and retighten every few rounds?

I saw the tape suggestion and will try it.

Is lock tight good here?

Is this a common occurrence?

Thanks,
Earl
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Re: Forearm screws backing out
« Reply #5 on: August 05, 2006, 02:10:12 AM »
No for me it is not a common occurrence. I currently have 5 complete Encores, 45 Cal M/L, two 50 Cal M/lL's , a 7mm08 and a 22-250. I have never had a forearm screw back out.

Find a compression washer and try it.
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA
Pages: [1]   Go Up
« previous next »