« previous next »
Pages: [1]   Go Down

Author Topic: Anyone have Bob Munden work on a revolver?  (Read 1254 times)

0 Members and 1 Guest are viewing this topic.

Offline HAMMERHEAD

  • GBO Supporter
  • Trade Count: (0)
  • A Real Regular
  • *****
  • Posts: 508
  • Gender: Male
Anyone have Bob Munden work on a revolver?
« on: July 03, 2006, 09:02:23 AM »
I'm ready to send my Ruger 50th Annivesary .357 Blackhawk out to Munden Enterprises for a level 1 action/trigger job.
I tried the poor mans trigger job and didn't like it. I could polish the internals myself. but that doesn't remove the creep in the trigger. Also he tunes the cylinder lock, I would have no clue on that.
Anyone have him work on their single action?
Logged

Offline jd45

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 537
Re: Anyone have Bob Munden work on a revolver?
« Reply #1 on: July 14, 2006, 02:39:05 AM »
HAMMERHEAD, if you go to handgunsandammo.proboards36.com, I believe you'll see several posts regarding Mr. Munden's work, which I understand, is top-shelf. I have an SAA I plan to send him to work his majic on at some point in the future, JD45
Logged

Offline paul105

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 304
Re: Anyone have Bob Munden work on a revolver?
« Reply #2 on: July 20, 2006, 12:25:52 PM »
Logged
Pages: [1]   Go Up
« previous next »