« previous next »
Pages: [1]   Go Down

Author Topic: Encore Hammer Extension Suggestions  (Read 515 times)

0 Members and 1 Guest are viewing this topic.

Offline mhwwlmc

  • Trade Count: (0)
  • Member
  • *
  • Posts: 13
  • Gender: Male
Encore Hammer Extension Suggestions
« on: August 27, 2006, 12:06:27 PM »
I am looking for a Hammer Extension for my T/C Encore 209 x 50 ML. I tried the RMC (Rightnour Mfg. Co.) model, but I can't get it tight enough to stay on. After a few hits it slides forward. What extension will stay on without any movement?
Logged

Offline Tentman

  • Trade Count: (0)
  • Member
  • *
  • Posts: 27
Re: Encore Hammer Extension Suggestions
« Reply #1 on: August 27, 2006, 03:45:53 PM »
Hello

Does the old " drill a hole through the hammer" and tap it for an old style winchester  type extension work with Encores.  I know it does with Handi rifles.  Hammers usually either require spot annealing or a special drill/tap to get through the hard bits.

Cheers
Logged

Offline TC2

  • Trade Count: (0)
  • Member
  • *
  • Posts: 29
  • Gender: Male
Re: Encore Hammer Extension Suggestions
« Reply #2 on: August 28, 2006, 09:01:49 AM »
I use the one from Mike Bellm (www.bellmtcs.com).  It has not moved yet and I have had no missfires even after lightening the trigger. 

Logged
------------------------
TC2

Offline Johnny Reb

  • Trade Count: (0)
  • Member
  • *
  • Posts: 96
Re: Encore Hammer Extension Suggestions
« Reply #3 on: August 28, 2006, 02:20:24 PM »
I just got one from Bellm Tc's, has three set screws, I haven't done any shooting since I put it on, but it doesn't look like it's gonna move any.
Logged
Proud member of the vast right wing conspiracy

Not fooled by the liberal media
Pages: [1]   Go Up
« previous next »