« previous next »
Pages: [1]   Go Down

Author Topic: shortening pull/replacement recoil pad  (Read 656 times)

0 Members and 1 Guest are viewing this topic.

Offline Tacoma

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 139
shortening pull/replacement recoil pad
« on: April 13, 2003, 06:59:59 AM »
I'm looking to recduce the length of pull on my 0/u shotgun bu 1/2 " or so.  There is nobody around that can cut the stock in short time and I'm still shooting it weekly. I don't really want to do it myself unless I have to. It currently has a factory recoil pad that is 7/8" thick. Can anyone suggest a thinner recoil pad ? I'm thinking if I can fid something made out of a more modern material but only 3/8-1/2" or so, it might be just enough.

BTW Existing pad is 5.25x1.875"x.875 and curved.
Logged

Offline RON KONTOWSKY

  • Trade Count: (0)
  • Member
  • *
  • Posts: 64
    • HTTP://WWW.DEANSGUNSHOP.COM
shortening pull/replacement recoil pad
« Reply #1 on: April 13, 2003, 07:53:46 AM »
You can go with a KICK-EZZ pad 1/2", slightly warm pad to form to the curve of the stock and grind to fit, watch your heel and toe, this will shorten your L.O.P., AND ONLY TAKE UP YOUR TIME AT THE BENCH.
GOOD LUCK.

RON KONTOWSKY
ACTIONS BY R.A.K.
Logged
YOU`RE ONLY AS GOOD AS YOUR LAST JOB!
MAKING THE WORLD A BETTER PLACE ONE GUN AT A TIME.
DEANS GUNSHOP 2
586-716-3460
www.deansgunshop.com
Pages: [1]   Go Up
« previous next »